I have run into couple of issues i can't seem to solve.


First one is if log on and hit force buff it will not cast war spells or go into

combat mode at all. The window says idle => casting but does not go into combat mode.

If i log off and back on and then check run macro, works great.


The second one is if i cast a vuln to lure a critter close it will not cast wars.

I have to log off and back on for it to work correctly.


Been thinking that something in the macro setting is causing it, but can't point at one

thing and say thats it.


any ideas anyone.


thx

dodge

You have to start the macro before it will do anything, even force-buff. CTRL-F1 or clicking the Start Macro will fix this. As for vulns, I'm not sure what the issue is there, as I've never had any problems.


C

 

-----signature-----

Ty for the reply


I must have a incorrct install or something because it will buff without checking run macro first.

It may be that i have not been checking run macro before force buff is causing the problem, will do that from now on,


thx again

dodge

I'm not IG right now either, I'm just pulling from memory. I'm fairly sure you have to start it first though, but I may be wrong.

 

-----signature-----

I just tested it by starting the macro then force buffing.

Went into eo up top and it would not cast wars. I loged off and back on and it worked fine.

Casted a imperil and it stopped casting wars.

I will uninstall the program, dump the folder and reinstall.

I hope i am not setting up the macro profile wrong, not sure what it would be.

I don't have the don't cast wars buttong checked

thx

dodge

The only thing it will do without being started first is the forced rebuff.